Shure UC Manuale di Servizio Scaricare il pdf (Pagina 11)

Shure UC4 Diversity Receiver

Parts Designations

25C1045 (TK)

Reassembly

1. Insert the rear circuit board components into their mating chassis

holes, and lower the circuit board into its correct position.

2. Secure the circuit board with the previously removed screws.

3. Plug in the connector between the dc power receptacle and the

circuit board.

4. Replace all previously removed screws, nuts, and washers to the

back of the unit.

5. Snap the front circuit board with standoffs into the chassis front.

6. Push the power knob in to snap it back onto the power knob

shaft.

7. Line up the front panel, and push the front panel toward the

chassis. Make sure the ribbon cables are positioned to clear

light pipes.

8. Latch both bottom and top tabs to the front of the chassis.

9. Slide the top cover onto the chassis until the cover is tight

against the front panel.

10. Secure the top cover with the previously removed screws.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Nessun commento

Shure UC Manuale di Servizio Pagina 11